游戏里的战斗激情,免费无码毛片一区二区A片小说 ,忍着娇喘人妻被中出中文字幕,中文字幕在线亚洲二区

CH-152_CH-252低功率設備恒溫器和無限控制機構OMEGA歐米茄

35至315°C（95至599°F）溫度范圍（SA系列）

無指示（SA系列）

120和240 V，單相（SA系列）

應用

器具

任何允許與加熱表面直接接觸的裝置

CH系列

機械雙金屬操作

旋鈕設置0至***瓦

雙刀單擲（DPST）快速動作

正斷開

120或240 V、1800和3600瓦

SA系列

特征

必須牢固地安裝在加熱表面上

CH-152_CH-252低功率設備恒溫器和無限控制機構OMEGA歐米茄

CH系列

這是一個廉價但積極的實驗室或工業加熱板控制，該系列也可用于控制舒適加熱器，小電爐，模具，臺板和其他應用，在開關的電流額定值需要無限控制。

特征

簡單。沒有凸輪或杠桿可調整。沒有電機燒壞。

雙金屬作用于低于Hi的設置，以限制電輸入并降低溫度。

用于低于80°C（179°F）的環境

對于較高的交流和所有直流加熱負載，使用磁性接觸器。

在120或240伏電壓下，對高達15安培的非感應負載進行無限控制?？上蜃蠡蛳蛴肄D(zhuǎn)動，以選擇0至100%瓦數的適當熱量，對總瓦數的前50%進行無限控制。

在高位置持續通電，在其他設置下，它在一個簡單的雙金屬計時器的控制下提供選定的輸入電平。

只有3個安裝孔需要安裝在盒子或面板中。

CH-152_CH-252低功率設備恒溫器和無限控制機構OMEGA歐米茄

35 to 315°C (95 to 599°F) Temperature Range (for SA Series)

Non-Indicating (for SA Series)

120 and 240 V, Single Phase (for SA Series)

Applications

Appliances

Any Device Which Permits Direct Contact With Heated Surface

CH Series

Mechanical Bi-Metal Operation

Knob Setting 0 to *** Watts

Double-Pole, Single-Throw (DPST) Snap-Action

Positive Break

120 or 240 V, 1800 & 3600 Watts

SA Series

Features

Must Be Firmly Mounted to Heated Surface

Temperature differential of approximately 3 to 11°C (5 to 20°F) depending on rate of temperature change, location, mounting, etc.

Slow make and break single pole single throw switch cannot be used for pilot duty with a magnetic contactor.

Temperature adjustment knob or set-screw adjustment is an option.

CH Series

An inexpensive but positive control for laboratory or industrial hotplates, this series can also be used for controlling comfort heaters, small electric furnaces, dies, platens and other applications where infinite control is required within the current rating of the switch.

Features

Simplicity. No cams or levers to adjust. No motor to burn out.

Bi-metal acts at settings less than HI to limit electrical input and depress temperature.

For use in ambients less than 80°C (179°F)

For higher ac and all dc heating loads, use magnetic contactors.

Gives infinite control for non-inductive loads up to 15 amperes on 120 or 240 volts. Can be turned either to left or right to select proper heat from 0 to *** wattage with infinite control over first 50% of total wattage.

Energized continuously in HI position, at other settings it delivers selected input level under control of a simple bi-metal timer.

Only 3 mounting holes are necessary to install in box or panel.